Expamet PT250 Type 4 Wall Ties 250mm - 250 Pack

Expamet PT250 Type 4 Wall Ties are 250mm stainless steel housing ties for 100–125mm cavities, supplied in packs of 250.

The PT250 Powertie is a Type 4 housing wall tie designed for masonry cavity wall construction where a light-duty housing tie is specified. It is commonly used in domestic cavity wall construction, extensions and party wall applications, subject to the project design, exposure conditions and specification.

Key Features

• Expamet PT250 Powertie wall tie
• 250mm Type 4 housing wall tie
• Suitable for 100–125mm cavity widths
• Stainless steel construction for corrosion resistance
• Type A to Part E of the Building Regulations for party wall construction
• Safety end design to reduce injury risk during handling and installation
• Supplied in a 250 pack

Specification

When to Use PT250 Wall Ties

PT250 wall ties are typically used where the cavity width is between 100mm and 125mm and the specification calls for a Type 4 housing tie. They are a common choice for domestic masonry cavity walls and extensions where this cavity range and tie type are suitable.

If your cavity is 75–100mm, a 225mm wall tie may be required. If your cavity is 125–150mm, a 275mm wall tie may be more suitable. Always check the stated cavity range before ordering.

Important Selection Note

Wall ties should not be selected by length alone. Before ordering, check the required tie type, cavity width, wall construction, building height, exposure conditions and any engineer, architect, building control or warranty-provider requirements.